![]() You may need to apply one final coat after sanding these out. When you're done, any runs or drips (which spraying a thin coat one section at a time should greatly diminish) can be sanded out with your sanding sponge. This will keep the paint from cracking as it cools. Turn off the oven and leave the radio in there, so that it will gradually cool down along with the oven. Then just let the radio bake for a few hours. Just place the radio on the middle shelf of the oven and turn on to a very low temperature, around 110 degrees Fahrenheit or so. A word to the wise - you might want to wait until there are no responsible adults around to catch you using the oven for this :-) ![]() You can replicate this procedure with the oven in your own kitchen. Original factory paint jobs were actually baked on! This is why they're still so durable and hard to strip. Be patient to avoid drips! Let the radio dry overnight. Repeat this process until you've built up three or four very thin coats over the entire radio. Spray the front and let dry, spray the left side and let dry, then spray the right side, and let dry. Spray the top first, and let dry for at least a half an hour or so. Put on a number of thin coats, spraying only one horizontal section of the radio at a time. For radios that were originally painted white, I've found that using an Antique White best duplicates the aged appearance of an original paint job. ![]() Sand this down a bit and reapply if needed. When dry, apply a coat of primer to give yourself a good, smooth undercoat. Then, wash the radio in a little soapy water, using an old toothbrush to get in all the corners and crevices, and let dry COMPLETELY. Just make sure you leave yourself a nice smooth finish to paint over. You'll probably sand right through the original paint in many areas. Instead, use a sanding sponge and sand over the entire cabinet, paying particular attention to smoothing over any chips or flakes in the original paint. It's much too messy and caustic to bother with. So, here's a method that's worked very well for me.įirst, don't bother stripping the old paint. We touched a bit on this in our 3-part series on Bakelite repair, but I don't think we ever covered a step-by-step method of repainting Bakelite. I got a question from an Old Radio Newsletter subscriber about how to best repaint a chipped factory paint job on an old Bakelite radio. GETTING A FLAWLESS FINISH PAINTING BAKELITE
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |